Proxmark3 community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

Announcement

Time changes and with it the technology
Proxmark3 @ discord

Users of this forum, please be aware that information stored on this site is not private.

#1 2020-06-28 08:29:23

Taha
Contributor
Registered: 2020-06-24
Posts: 12

Using an ARM Microcontroller instead of a PC (OS-Based platforms)

I want to eliminate the need for having a PC (OS-based platforms and the requirement for a software-client) as the Proxmark's controller. I want to use an STM Microcontroller (Or another ARM microcontroller) as the controller of proxmark3, sending and receiving commands over, but the commands as I sniffed the USB port (using Wireshark software)are coded into hex values, and the responses as well. I did not find any material regarding the protocol of the codded commands and the decoding of the codded returned data. Has anybody substituted PC with a microcontroller? If so, can you please share your codes? of not, any help and guidance in doing so would be highly appreciated?
Moreover, can you please also help me where I can find CMD-based client source codes? (are those the ones in source codes of the MP3, client folder?)

My email: prooksima@gmail.com

Offline

#2 2020-09-07 21:55:14

easyeasy
Contributor
Registered: 2020-09-06
Posts: 10

Re: Using an ARM Microcontroller instead of a PC (OS-Based platforms)

Search USB CDC

Offline

Board footer

Powered by FluxBB