Proxmark3 community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

Announcement

Time changes and with it the technology
Proxmark3 @ discord

Users of this forum, please be aware that information stored on this site is not private.

#1 2019-05-05 14:17:42

Proxmax
Contributor
Registered: 2019-04-04
Posts: 4

Config block for T55x7 to emulate Nedap

Hi, I have a Nedap chip that can be read with "lf nedap read". I get the Raw, UID, i and checksum.
I cloned the blocks from the raw to the T55x7 blocks, e.g. using lf t55xx wr b 1 d 12071c65.
Now, I don't know how to set the block 0. Could anyone give me a hint or point a me to a beginner friendly guide?
Thanks smile

Offline

#2 2019-05-09 09:23:32

somm15
Contributor
Registered: 2019-05-08
Posts: 4

Re: Config block for T55x7 to emulate Nedap

Please try this:
lf t55xx wr b 0 d 907f0042

Regards,

Offline

#3 2019-05-11 12:12:42

Proxmax
Contributor
Registered: 2019-04-04
Posts: 4

Re: Config block for T55x7 to emulate Nedap

@somm15 Thanks a lot, I appreciate your reply.
Now the card can be read with the "lf nedap read" command but exactly the second half of the Raw has different values.
Best,

Last edited by Proxmax (2019-05-11 12:23:59)

Offline

Board footer

Powered by FluxBB