Proxmark3 community

han young hwang

Member

Registered: 2010-01-28

Posts: 2

tune command error

Before I reflashing there was no error message
but after reflashing bootloader, fpga, osimage
there is an error message like below

> tune
#db# Measuring antenna characteristics, please wait.
unrecognized command 00000410

so I redo reflashing fpga, osimage
but still there is an error....

Help me please....

p.s

The reason I reflashed is there was an error hi14alist command.
When I did that command prox program was down and there was no response.
But after reflashing hi14alist command is ok. It responds something message...
But tune command doesn't operate.

I bought proxmark board last week.

Thanks for your help....

Last edited by han young hwang (2010-02-01 04:01:11)

d18c7db

Contributor

Registered: 2008-08-19

Posts: 292

Re: tune command error

Assuming you use the windows prox.exe client, after flashing to the latest version, use the prox.exe generated in the client directory.

han young hwang

Member

Registered: 2010-01-28

Posts: 2

Re: tune command error

Thanks for your advice ^.^

when I reflashed I used compiled files at proxmark folder, but I use prox.exe file at pm3-20090905-r216 folder.
Because at pm3-20090905-r216 folder I couldn't compile boot, fpga, os image files, but prox.exe is compiled well.
And at proxmark folder I could compile boot, fpga, os image files but couldn't prox.exe.

so I use boot, fpga, os image files at pm3-20090905-r216 folder which are already exist when I unzip 2009.09.05.ProxSpace.zip file downloaded from this site.

Thank You. ^^

And one more question.

There is no problem if I use the windows prox.exe client?
I use at windows xp sp2.