Proxmark3 community

vizon

Member

Registered: 2015-03-07

Posts: 2

Issue flashing PM3 precompiled

Hey guys! Got my new PM3 and I am having some issues

I used the 0.0.7 package from the forums.

I successfully flashed all of the items to the device, but there is an issue. In the GUI I get additional options that aren't recognized. The commands related to t55x7 cards and AWID cards don't work. It just lists all the available commands.

I have flashed the bootrom, OS, fpga etc.

I have search high and low and have yet to come across information pertaining to why commands aren't being recognized on the PM3.

Thank you for the help!

asper

Contributor

Registered: 2008-08-24

Posts: 1,409

Re: Issue flashing PM3 precompiled

Wait for the next pre-compiled release, many changes under the hat.

You can always use the command line to use the commands not working, the gui is only an helpful interface.

Last edited by asper (2015-03-07 01:24:02)

vizon

Member

Registered: 2015-03-07

Posts: 2

Re: Issue flashing PM3 precompiled

asper thanks so much for the quick reply. The GUI has the commands. The issue is that the commands dont exist in the firmware. I have tried the command line and get the same response.

asper

Contributor

Registered: 2008-08-24

Posts: 1,409

Re: Issue flashing PM3 precompiled

Some lf commands are wrong in 0.0.7 because of the many changes, try to look at command help to see if there is a wrong syntax/name or just wait for a new release.

iceman

Administrator

Registered: 2013-04-25

Posts: 9,506

Website

Re: Issue flashing PM3 precompiled

If you use the commandline,  then the "lf t55xx" commands is  "lf t55xx readblock"  "lf t55xx readblockPWD" ..
just run a  "lf t55xx"  to see the help texts.