Proxmark3 community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

Announcement

Time changes and with it the technology
Proxmark3 @ discord

Users of this forum, please be aware that information stored on this site is not private.

#1 2019-07-31 00:19:33

jh67
Contributor
Registered: 2019-07-31
Posts: 2

Hello! New to it all, Proxmark3 RDV4.0 arrived today!

Hi guys,

I am human, can confirm beep boop beep...

New to RF and Proxmark and reading like crazy to try and wrap my head around this complex world. My Proxmark3 RDV4.0 arrived today, got the firmware and software installed successfully but yet to understand:

How to 'arm' the device for standalone emulating.

I tried to clone my work badge as a test but it's a HF Mifare DESFire 4k card...from what I gather these are hard to crack? Anyone know if it's possible? Code from searching card below:

 UID : 5f 1f f3 43
ATQA : 00 04
 SAK : 20 [1]
TYPE : NXP MIFARE DESFire 4k | DESFire EV1 2k/4k/8k | Plus 2k/4k SL3 | JCOP 31/41
 ATS : 0a 78 80 70 02 20 63 cb b7 80 8b 30
       -  TL : length is 10 bytes
       -  T0 : TA1 is present, TB1 is present, TC1 is present, FSCI is 8 (FSC = 256)
       - TA1 : different divisors are NOT supported, DR: [], DS: []
       - TB1 : SFGI = 0 (SFGT = (not needed) 0/fc), FWI = 7 (FWT = 524288/fc)
       - TC1 : NAD is NOT supported, CID is supported
       -  HB : 20 63 cb b7 80
No chinese magic backdoor command detected
PRNG data error: Wrong length: 0
Prng detection error.

Valid ISO14443A Tag Found - Quiting Search

I am going to be using this for Red Teaming.

Offline

#2 2019-07-31 00:39:54

Mackwa
Contributor
Registered: 2016-06-10
Posts: 51

Re: Hello! New to it all, Proxmark3 RDV4.0 arrived today!

welcome to the forum, you can repost qour question after you have full access...
just for now, your work badge does not seem to be a MF DESFire card, it's only one of the possible options listed by the proxmark ...
for reference: ATS of a MF desfire: 75 77 81 02 80

Offline

#3 2019-07-31 04:43:59

iceman
Administrator
Registered: 2013-04-25
Posts: 9,497
Website

Re: Hello! New to it all, Proxmark3 RDV4.0 arrived today!

Welcome and I suggest you read http://www.proxmark.org/forum/viewtopic.php?id=1125 as an introduction.

Your access rights has been updated.

Offline

Board footer

Powered by FluxBB