Proxmark3 community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

Announcement

Time changes and with it the technology
Proxmark3 @ discord

Users of this forum, please be aware that information stored on this site is not private.

#1 2019-06-21 05:57:45

bestcarsauto
Contributor
Registered: 2019-06-21
Posts: 12

Hello, I just bought a Proxmark3 RDV4

Hi
I just bought a Proxmark3 RDV4 without knowing anything about RFID hoping to learn a little about this fascinating tool. I already start looking for videos and all info that I can find in the internet and I can see that its a lot of information but most of this info is for the old units and is not too much about the Proxmark3 RDV4 anyway hope in this forum get the help that I need.
When I saw some videos gave me the impression that as soon I get the machine I can be  cloning some tags and Id cards but that was no possible because the unit even though following the instructions using a power supply the machine does not recognize the pieces that I want to clone not even the cards that came with it, at this point I'm not sure if is the unit itself that is defective or if I'm doing something wrong, then I try to install it in the computer and followed the instructions (https://www.youtube.com/watch?v=zzF0NCMJnYU&feature=youtu.be) and at the end I get a message: "Unknow+User@DESKTOP-4G3DULf MING64 ~" so I'm stuck because I can not find anything about the problem.
Any advice will be appreciated.
Thanks

Offline

#2 2019-06-21 08:26:50

iceman
Administrator
Registered: 2013-04-25
Posts: 9,497
Website

Re: Hello, I just bought a Proxmark3 RDV4

Welcome and I suggest you read http://www.proxmark.org/forum/viewtopic.php?id=1125 as an introduction.

Your access rights has been updated.

Offline

Board footer

Powered by FluxBB