Proxmark3 community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

You are not logged in.

Announcement

Time changes and with it the technology
Proxmark3 @ discord

Users of this forum, please be aware that information stored on this site is not private.

#1 2018-12-02 20:33:55

chimera
Contributor
Registered: 2018-10-26
Posts: 12

Hotel card dumped - How to read data blocks

Hello,

Actually I am playing with a Mifare classic hotel card. At this point I was able to fully dump the card, thanks to hardnested command set.
For sector 0 a 1st key was used, remaining sectors do have a 2nd key in use.

Actually I am having to problem to understand the data blocks (no value blocks present), conversation from HEX numbers to ASCII or DEC just shows junk....

What is the correct approach to interpret data blocks? How can I find for example room number, Name .....

Thanks for guiding me in the right direction smile

Chimera

Last edited by chimera (2018-12-02 20:39:05)

Offline

#2 2018-12-03 20:14:21

chimera
Contributor
Registered: 2018-10-26
Posts: 12

Re: Hotel card dumped - How to read data blocks

Somebody can provide a hint how to proceed?

Many thanks in advance!

Chimera

Offline

#3 2018-12-03 22:35:14

szymonunion
Contributor
Registered: 2009-07-05
Posts: 46

Re: Hotel card dumped - How to read data blocks

Hi,

maybe only UID is important for door lock ?

Regards,

Offline

#4 2018-12-04 16:10:41

Bergera
Contributor
Registered: 2018-11-07
Posts: 7

Re: Hotel card dumped - How to read data blocks

I've run into a couple different things here.

I've seen some that use Mifare Application Directory but most others don't, may be check and see if yours uses MAD?

I haven't had any that specifically are tied to the UID yet.

I have yet to figure out how anything is formatted yet.

Offline

Board footer

Powered by FluxBB