I copy many time of Paradox ProxII... , when I read by( actually most time I use these 2 command will work)
proxmark3> lf t55xx detect
proxmark3> lf t55xx dump
The block0 always the same, never see different, but this case is different, how to write block0 ?
Thanks iceman.
]]>When verifying, you need detect, then dump it again.
Which kind of tag is this? Never seen this config block before?
]]>unknown.
proxmark3> lf t55xx detect
Modulation : FSK2a
Bit Rate : 4 - RF/50
Inverted : Yes
Offset : 33
Block0 : 0x00107068
proxmark3> lf t55xx dump
0x00041C1A 00000000000001000001110000011010 [0]
block0 is wired, should be same with block 0 : 0x00107068
0xB01475A1 10110000000101000111010110100001 [1]
0x4F53B5A0 01001111010100111011010110100000 [2]
0xA2911452 10100010100100010001010001010010 [3]
0x00000000 00000000000000000000000000000000 [4]
0x00000000 00000000000000000000000000000000 [5]
0x00000000 00000000000000000000000000000000 [6]
0x00000000 00000000000000000000000000000000 [7]
proxmark3>
then try to write to T5577:
lf t55xx wr 0 00107068 00000000
lf t55xx wr 1 B01475A1 00000000
lf t55xx wr 2 4F53B5A0 00000000
lf t55xx wr 3 A2911452 00000000
not working....
]]>